Planning: All indoor flooring installations should have a commercial quality floor sealer/finish applied, preferably before traffic is allowed. When this is not possible, soil from foot traffic or other construction debris should be cleaned off with a cleaner/degreaser and vacuum. Sealer/finish should be applied as soon as possible for unbonded installations. Sealer/finish should be applied on bonded installations only after allowing adhesive to set properly according to manufacturer’s instructions. Sealer/finish is not recommended for outdoor installations.

Sealing: There are two basic types of sealers, strippable and non-strippable. The strippable variety is the easiest to apply and safest to work with. Apply sealer following label instructions for a clear, durable surface which dirt cannot penetrate. Sealer makes an adequate finish coat. It is not necessary to apply sealer often unless it becomes worn from neglect.

Finishing: For greater beauty, protection and ease of maintenance, we recommend a coat of wax or flexible finish be applied over the sealer following the label instructions. Renew the wax or flexible finish as necessary.

Stripping: Removes floor finish and sealer and should only be done when renewal of finish or sealer no longer produces satisfactory results. Follow label instructions. A power scrubber or buffer may be used on fully bonded installations following the sealer/finish manufacturer’s instructions for stripping off old floor finish.

Maintenance: Tire Veneer flooring installed indoors with a sealer/finish applied, should be cleaned and maintained in accordance with the sealer/finish manufacturer’s recommendations for rubber floors. Otherwise, maintenance of the floor by damp mopping with a neutral cleaner is acceptable. A power scrubber or buffer may be used on fully bonded installations following the sealer/finish manufacturer’s instructions for cleaning. When burnishing, a compatible restorer is recommended for lubrication. Tire Veneer flooring installed outdoors may be cleaned with a mild detergent, nylon bristle scrub brush and water. Ensure all soap residue is rinsed from the Tire Veneer flooring before allowing to dry. Power washing using medium pressure nozzles may also be utilized for outdoor installations.

General Precautions: Care should be exercised when moving or relocating equipment over Tire Veneer flooring to prevent damage to the floor. Do not scrub or strip fully bonded floors until at least 4 or 5 days after installation so that the rubber flooring will have become well seated in the adhesive. The use of pads, wide casters/rollers, furniture/equipment cups, may prevent excessive indentation. The performance and guarantee of the products used in preparation, testing, installation and maintenance of rubber flooring, during and after installation, remain with the manufacturer of said product, not Yemm & Hart.

Recommendations: Yemm & Hart recommends Taski floor care products manufactured by Lever Industrial Co @ 800-827-5487